System Connection Guide

Inspect contents

After unpacking, inspect the contents to confirm you have the above items:

NX-E270 two front speakers (1, 2), NX-E270 two surround speakers (3, 4),

NX-C270 one center speaker (5), SW-P270 powered subwoofer (6),

HTR-6025 AV Receiver (7) with remote control. Also included, but not shown, are

five speaker wires, one subwoofer cable, AM and FM antennas, fasteners, non-skid

pads, and three related Owner’s Manuals.

1

center speaker (5). The positive (+) side of the wire with the white stripe attaches to

3

white stripe attaches to the red terminal. The negative (–) side attaches to the black terminal.

5

Connect the subwoofer cable to the subwoofer (6). Set subwoofer VOLUME control to

half-way mark and POWER to OFF (rear panel).

Components must not be plugged in while connecting them.

6

Connect antennas

Components must not be plugged in while connecting them. Wait until all connections are made before

plugging in your components.

Connect a video monitor

Connect the MONITOR OUT jack of the receiver and the video input jack of your video

Connect a DVD player (video)

Connect the DVD VIDEO IN jack of the receiver and the video output jack of your

DVD player using an RCA video cable (not included).

5

6

1 Front right speaker

• Be sure to put batteries in your remote control (see Owner’s Manual for instructions).

• Refer to your Owner’s Manuals for each component in your system for more

information.

Connect a CD player

Connect CD jacks of the receiver and the output jacks of your CD player using RCA

audio cables (not included).

STEP 3: Plug in

first, then the subwoofer and other components. Please see each of your respective Owner’s

Manuals for recommended guidelines and settings.

Connect MD/CD-R IN/OUT jacks of the receiver and the input/output jacks of your