5
Chapter 2: Using Your Steam Generator
Select the temperature of the soleplate by turning the dial (8) on the iron to the desired posion.
Wait a few moments unl the iron heang light (10) is o.
It will indicate to you that the soleplate has reached the requested temperature.
While ironing, the iron heang light (10) may turn on and o, the temperature adjusts
without interrupng your ironing.
Help
To know the best suitable temperature for each texle, check the laundry care label of the
arcle to be ironed. Please note that during use, the temperature light goes on from me
to me. It signies that the iron is heang up to the set temperature.
If a fabric is made with various kinds of bers always select the soleplate temperature in
adequacy with the most delicate one.
If you select a lower temperature while ironing, wait unl the iron has cooled down to the set temperature before
you connue ironing.
If the temperature is too low, some drops of water could escape from the soleplate. Please raise up the
temperature above the 2 dots (••) to avoid this issue.
Connect the appliance with the mains cord to the earthed socket. Press on the main switch (12), the power
light (11) will illuminate red color, turn the temperature dial (8) to your desired seng, the iron heang light
(10) will illuminate informing you that the appliance is heang up, this will turn o when the soleplate reaches
the selected temperature.
Aer approximately 1 minute, the iron heang light (10) will go o, then you can start ironing.
N.B.
The rst me the appliance is used, some fumes, dust and a smell should appear.
It’s quite normal and will quickly disappear.
This is due to a treatment applied to the soleplate that improves the steam performance.
Before use, please use the iron as described in Chapter 2.4 Vercal Steam Ironing.
Chapter 1.3 - Switching on the Appliance
Chapter 2.1: Regulang the Soleplate Temperature
Dry Ironing
Select the temperature of the soleplate following the indicaons of chapter
3.1. Start your ironing without pressing the steam trigger (7), when the
soleplate reaches the appropriate temperature.
Steam Ironing
Select the temperature of the soleplate following the indicaons of chapter
3.1. The steam will be ready to be used aer 1 minute and the dedicated
lamp will turn o. Starng from that me you can begin your
ironing and press the steam trigger (7) for having steam.
N.B.
During the use, you should hear some noise coming from your steam generator. It’s totally normal. It signies
that a pump injects water into iron soleplate.
Chapter 2.2 - Ironing
Fig. 6: Pressing Steam Trigger Graphic
GB